Description
If you are requiring the similar or same replacement cutters as the ones on Piscifun Fishing Pliers, then this is what you need. Tungsten Carbide makes the cutters exceptional sharp.
Fit the pliers which have the similar cutters as the ones on Piscifun Pliers.
- Step 1: Screw off the original cutters, remember the specific position of each cutter.
- Note: Please grease it before putting the new cutters on if there is dust.
- Step 2: Close the jaws tight enough, put the replacement cutters on as the original goes. Tighten the screws a little bit with Allen Wrench.
- Note: Do not screw it too tight.
- Step 3: Adjust the cutters a little bit if they are not on the right position. Fully tighten the screws.Your new cutters are good to use then.
- Note: The cutters is not for saltwater pliers.
